Friday, November 2, 2012
Circuit »
Home »
electronic hobbyist
»
Hobby Electronics
»
hobby in electronics
»
IC 555
»
Op amp
»
stickers
»
Automatic Street Light Controller Circuit Diagram
This circuit is an automatic street light controller. Sensors used to detect changes in light is LDR (Light dependent resistor), the working principle of Light dependent resistor
is exposed to light when the resistance value of LDR great, but if not
exposed to light or dark then the resistance value of LDR.
LDR is a special type of resistance whose value depends on the brightness of the light which is falling on it. It has resistance of about 1 mega ohm when in total darkness, but a resistance of only about 5k ohms when brightness illuminated. It responds to a large part of light spectrum.
When light falls on the LDR then its resistance decreases which results in increase of the voltage at pin 2 of the IC 555. IC 555 has got comparator
inbuilt, which compares between the input voltage from pin2 and 1/3rd
of the power supply voltage. When input falls below 1/3rd then output is
set high otherwise it is set low. Since in brightness, input voltage
rises so we obtain no positive voltage at output of pin 3 to drive relay.
Automatic Street Light Controller Circuit Diagram
LDR is a special type of resistance whose value depends on the brightness of the light which is falling on it. It has resistance of about 1 mega ohm when in total darkness, but a resistance of only about 5k ohms when brightness illuminated. It responds to a large part of light spectrum.
Subscribe to:
Post Comments (Atom)
that's very good circuit for practically
ReplyDelete