Wiring Diagram

The A4558 is a monolithic Integrated Circuit designed for dual operational amplifier.

Absolute maximum ratings of A4558 Ap-amp

    Supply voltage VCC 20 or ±10 V
    Differential input voltage VIND 20 V
    Input voltage VIN ±10 V
    Power Dissipation PD 300 mW
    Operating temperature Topr -45 ~ +85 °C
    Storage temperature Tstg -55 ~ +150 °C

Any number of normally-open switches may be used. Fit "tilt" switches that close when the steering is moved or when the bike is lifted off its side-stand or pushed forward off its centre-stand. Use micro-switches to protect removable panels and the lids of panniers etc.

The alarm's standby current is virtually zero - so it won't drain your battery. Once activated - the rate at which the siren switches on and off is controlled by R7, R8 & C4. For example, increasing R7 will make the sound period longer - while increasing R8 gives longer silent periods.

The circuit is designed to use an electronic Siren drawing 300 to 400mA. It's not usually a good idea to use the bike's own Horn because it can be easily located and disconnected. However - if you choose to use the Horn - remember that the alarm relay is too small to carry the necessary current. Connect the coil of a suitably rated relay to the "Siren" output. This can then be used to sound the Horn, flash the lights etc.

The circuit board and switches must be protected from the elements. Dampness or condensation will cause malfunction. Connect a 1-amp in-line fuse AS CLOSE AS POSSIBLE to your power source. This is VERY IMPORTANT. The fuse is there to protect the wiring - not the alarm. Exactly how the system is fitted will depend on the make of your particular machine - so I'm unable to provide any further help or advice in this regard.

In the monostable mode, the timer 555 acts as a "one-shot" pulse generator. The pulse Begins Pls the 555 timer receives a signal at the trigger input That falls below a third of the voltage supply. The width of the output pulse is determined by the time constant of an RC network, the which consists of a capacitor (C) and a resistor (R). The output pulse ends Pls the charge on the C equals 2 / 3 of the supply voltage. The output pulse width cans be lengthened or shortened to the need of the specific application by adjusting the values of R and C.